Honda305.com Forum

I just removed mine last night. :D Screw the rear axle in and tighten it the best you can with a rod or stout screwdriver in the axle hole. Then give it a couple hard whacks with a rubber or plastic mallet on the rod or screwdriver to tighten it even more. Mine popped right off. Its a taper fit. Scr...

Think of what?

I'm in the process of reassembling my engine after new rings, a cylinder hone, and new gaskets. I also removed the cam to do some work on one of the fins that needed welding. I set up the side clearance of the cam while it was off the engine. Put the head on, installed the cam chain, and tightened u...

Here is a pic of a CA78 number on my Dream.

I cleared them last night. I was letting the head sit in some hot soapy water last night for its fianl cleaning and rinse before I re-assembled it. Checked again after they sat in hot water for over an hour and they are now clear. I got anothr reply saying that they were discontinued after '67, so I...

I'm assuming these air vent posrt should be clear.



Exactly where do they lead to and any suggetions on how I can clear them.

Thanks

Anybody know of a source for the oil seals? Maybe somebody sells all of them in a kit? I think I read somewhere that all seals on the 305 could be replaced without a complete engine teardown. Is that correct? Here's the seals that I need. CLUTCH / LEFT CRANKCASE COVER 20 OIL SEAL 14X25X7 91202-250-0...