Search found 27 matches
I pulled the forks today, the fork oil was brand new. Regardless, I rinsed the forks out with mineral spirits: http://www.caferacer.net/forum/attachments/project-builds/45601d1483300522-cb77-project-fork-oil.jpg The fork tubes look serviceable to me... the chrome is perfect over the entire section o...
Providing the existing pump housing is not scored around the periphery or the face and you have new gears you should be fine. I was going to mention the hex bolt for parting the cases but you got there...... G the new housing can accommodate gears up to 9mm wide. because I have the 6mm gears, there...
I think I figured it out where that second washer goes... I had sent an email to Cappellini in italy and he got back to with this: http://i.imgur.com/PkeGVwP.jpg That didn't make sense to me at all upon reading it... I then sat down and drew out how I thought it should work/look: http://i.imgur.com/...
So I got started on the oil pump today. Drained the oil and pulled the pump and found this guy hanging out next to the screen: http://www.caferacer.net/forum/attachments/project-builds/43665d1481486980-cb77-project-washer.jpg Seems to be two bits of a chewed up washer. I'm going to get an extendable...
Some more progress today. I got the starter shimmed out so that the chain has a reasonable amount of slack, I loctite-ed and installed the bolt on the sprocket retainer, and I got the rotor (with new clutch hardware) installed on the crank with the woodruff key. It was a little challenging to get it...
I modified a clutch basket for my CYB Race-kit project. Haven't got around to the tensioner yet. If you don't want to make your own then the Cappelini one should do the trick. http://www.honda305.com/forums/duplex-primary-chain-t7635358.html G Thanks, I stumbled across your DIY while looking into t...
|