Clutch rod oil seal

jambretta · Post by **jambretta** » Tue Jan 17, 2017 12:34 pm

jleewebb - how's the Cappelini holding up? I just bought one and have not installed it yet. I'm curious if you lock-tited the two allen head bolts, or how snug you tightened them in. No one wants a countersprocket coming off.

jleewebb · Post by **jleewebb** » Tue Jan 17, 2017 12:57 pm

Only put about 100 miles on bike since installation...not enjoying riding in traffic as much as I once did. No leaks, don't anticipate any problem.

Loctite might have been a good idea, but I just tightened as much as I could with a t-handle. Something to keep in mind if I ever take that side cover off again.

Thnks, Lee

RCP_Espresso · Post by **RCP_Espresso** » Thu Jan 19, 2017 1:41 pm

jambretta wrote:jleewebb - how's the Cappelini holding up? I just bought one and have not installed it yet. I'm curious if you lock-tited the two allen head bolts, or how snug you tightened them in. No one wants a countersprocket coming off.

I just installed mine, I used a little blue Loctite on each bolt. I went hand tight, but I'll look up the torque specs just to be sure.

Honda305.com Forum

Clutch rod oil seal

so far so good