Points Screws

Greggie-e · Post by **Greggie-e** » Thu Dec 10, 2009 9:57 pm

Hi, my bike must have been previously owned by a butcher.

the screws that hold the points cover on and the screws that hold the points plate on are pretty much useless.

Apparently I need

The point cover plate uses 5x30 (old)JIS....0.9 thread pitch x 2
The breaker plate screws are 5x12 (old)JIS..0.9 thread pitch x 2

Fleabay guys want $26 postage to Australia, I think that is a tad too much, but i am willing to pay a reasonable amount.

Cheers,
Greg

Goodysnap · Post by **Goodysnap** » Fri Dec 11, 2009 5:34 am

Not that this is perfectly correct , however I could not fing the correct screws either, and mine were trashed also. I found some 10-32 screws at the hardware and tapped the holes to match.

Greggie-e · Post by **Greggie-e** » Sat Dec 12, 2009 6:06 am

If I can't find the right ones I am going to have to do something like that too, although I think I would prefer to make some screws on the lathe (ie pay someone else to make them)

e3steve · Post by **e3steve** » Sat Dec 12, 2009 5:47 pm

Greggie, drop an email to FASTFRED (FASTFREDKOREN@aol.com); he sometimes has the JIS screws on offer. Good guy to deal with too!

G'luck....

G-Man · Post by **G-Man** » Thu Dec 17, 2009 11:09 am

When I get to this bit of my CL77 resto - I intend to helicoil the holes back to a standard metric pitch.

http://www.tooled-up.com/Product.asp?PID=7765

That way I won't have to bother searching for crazy sizes.

I've used these on a number of restorations where 'monkeys' have been at work before me.

Cheers

G

e3steve · Post by **e3steve** » Thu Dec 17, 2009 3:08 pm

Agreed, G. I've been Helicoiling every thread in the casings, but I have left the JIS 5mm tappings alone; I got the necessary screws from FASTFRED.

AWILLIAMS64 · Post by **AWILLIAMS64** » Sun Dec 20, 2009 2:24 am

are the point cover screws the same on a 65 cb77? if so i have some that i bought directly from honda.

Honda305.com Forum

honda305.com Forum

Points Screws

Points Screws