CB72-77 Racer

G-Man · Post by **G-Man** » Sat Aug 01, 2015 2:55 pm

What style of bearing have you got on the right hand crank end? Roller or ball-race?

G

lloydy1 wrote:Had the casings back from the aqua blaster.

lloydy1 · Post by **lloydy1** » Sun Aug 02, 2015 2:07 am

G-Man wrote:What style of bearing have you got on the right hand crank end? Roller or ball-race?

G

Hi G

Roller bearings on the right hand side and as you can see in the pic ball on the left.

Dave

lloydy1 wrote:Had the casings back from the aqua blaster.

G-Man · Post by **G-Man** » Sun Aug 02, 2015 2:25 am

OK - thanks.

Don't see the picture, though...

G

lloydy1 · Post by **lloydy1** » Sun Aug 02, 2015 3:36 am

G-Man wrote:OK - thanks.

Don't see the picture, though...

G

Sorry my mistake. getting confused with what you were asking G. I haven't put a picture of the crank yet, but it does have the rollers and the ball bearings fitted.

Dave

G-Man · Post by **G-Man** » Sun Aug 02, 2015 8:31 am

Dave

No problem

G

lloydy1 · Post by **lloydy1** » Tue Aug 04, 2015 8:51 am

Some pics of the gear selector and the oil seal at the end of the selector. Doesnt seem to pass through the seal. Any clues on this one?

Dave

G-Man · Post by **G-Man** » Tue Aug 04, 2015 11:09 am

Dave

The bit on the end of the standard shift drum operates the neutral switch which isn't needed on your bike so you could just get a bung made to block that off. A simple aluminium plug with an O-ring should work.

G

lloydy1 wrote:Some pics of the gear selector and the oil seal at the end of the selector. Doesnt seem to pass through the seal. Any clues on this one?

Dave

Honda305.com Forum

honda305.com Forum

CB72-77 Racer