honda305.com Forum

bigscooter wrote:http://www.youtube.com/watch?v=-oKh1TJ1nJs
here's a tube of it.

Vid freezes for me @ 0:02

=/

From another thread:

If you did use the new needle in the carb kit what position did you put the clip on?If the bike starts without the choke on a cold start you are too rich.I went thru the same thing with one side not firing when it fouled the plugs and had to move needle clip up one notch.Now I ...

You got that right Allthumbs! This has been a head-scratcher.

Well, she runs again! Instant throttle response, nice ride....for about 10 minutes! Drivers' side cylinder it's def not hitting as it should. Exhaust is much cooler to the touch, and you can hear/feel/see the miss as your riding. Little ...

You can follow my posts as I've been doing the same thing for a couple months now! lol

Finally starting to understand what's up. Here's a Cliff's notes:

New battery. No spark. Trimmed plug wires. Set points to .014 at the highest cam lobe. Got spark. It's not a finished job as I neglected to set ...

I'm in the SAME boat bro right over here: http://www.honda305.com/forums/viewtopic.php?t=2807

Glad you got it worked out! Mine's too loud and it's almost 11:30PM so I'll have to wait until tomorrow to hopefully get mine together.


yes, thank you all. I charged the battery so I could see the light ...

YES! And I think you just schooled me why that is not the correct setup.

Are the points open .014 in the pic?. ..........lm


Pics of timing setup.

http://www.invizibletouch.com/1967dream/060908timing1.jpg
http://www.invizibletouch.com/1967dream/060908timing2.jpg
http://www.invizibletouch ...

AHA! I'm getting "it" now because my next post was going to show how I was setting them to .014 at the highest lobe and and the pc notch like _ and got it to run better than ever. Finally getting through my thick skull. Will report back after I loosen those OTHER 2 screws and adjusting the plate ...