honda305.com Forum

G-man, hope you are well. Do you know of any rear cl72 rims available?

Thanks for your help here. I replaced the clutch pushrod seal and the leak is gone.

So I put JB weld in the hole and then punched in a 2 cm piece of brass stock.

Still had a high volume oil leak...

So I decided to try to run the bike with the kickstarter cover off to try to see where the oil is coming from.
I posted the video to You Tube here--

https://www.youtube.com/watch?v ...

No I did NOT clean the rotor before pics were taken. I was surprised how dry and clean the rotor was.....

OK guys, I will replace the seal and not worry about the hole in the shaft.

Do you recommend using some type of sealant on the outside edge of the seal as the PO did?

Also I was planning on making a tool out of a bent and sharpened nail to help pry the old sea out. Any thoughts on that approach or ...

Yes I have lubed the chain. I use PJ1 for o ring chains. Advertised not to "fly off".

However, in the rear rim a good amount of semi clean engine oil has been collecting, this appears to be coming from the chain.

The clean oil leak that is dripping off the stator is fairly high in volume. A drip ...

Some other pics