Hi everyone - I have a question about the seats on the CA77's - were they the same throughout the Dream's production run, or are there differences in the front, where they attach to the bike frame? I have a 1964 CA77 305 that does not allow the gas tank to sit fully on the frame when the seat is installed, and vice-versa - the seat is about a half-inch too long to put the tank on, or, conversely, a half-inch too short to put the seat on when the tank is installed properly - so I'm wondering if it is the correct seat...? The seat attachment on this seat looks like the right one, but instead of the usual forks is closed and rounded and has a bolt going through them that goes through the bikes' mounting bolt and holds it on that way, as opposed to the fork-type I have seen that just slides onto the mounting bolts...is this correct? It looks kind of like the seat to a Sears Allstate, but it's not. I would attach a pic but I don't have one available right now - but I thought I'd ask. I'm wondering if the PO I got it from somehow mixed up the seats?? Or is there a trick to installing the seat and tank? Thanks; -John