Page 7 of 15
Posted: Wed Nov 26, 2014 1:49 pm
by Hahnda
6mm is the size I use. Kinda loose but spoke wrenches usually are a little loose.
Posted: Sat Nov 29, 2014 12:54 pm
by jugger18
Well i finally defeated the stuck bolt. Although i may have gotten a bit overzealous with the punch as I boogered the threads. I will have to figure something out there. Either cut off the boogered part or replace. Engine is free though.
Posted: Sat Nov 29, 2014 1:04 pm
by Hahnda
Easy enough to just replace it.
Sometimes there are sacrificial parts. Luckily it was the bolt and not the cover or the frame.
Posted: Sat Nov 29, 2014 1:09 pm
by jugger18
Yeah although every time I see one on the bay, they want $20 for it. Might just grond off those last 2 threads and see how it looks. If not good I will replace it. I have the rims soaking in Oxalic acid right now. The front looks like it may be good enough. The rear has a lot of flaking chrome near the edge
Posted: Sat Nov 29, 2014 1:16 pm
by Hahnda
Looks like its an M10x135 bolt. Replace it with another one unless you are really wanting an original one.
Posted: Sat Nov 29, 2014 1:31 pm
by G-Man
I often buy collections of parts like this. A quick trip to the zinc platers and you are good to go....
http://www.ebay.co.uk/itm/1966-honda-cb ... 51c62592bf
G
Posted: Sat Nov 29, 2014 1:58 pm
by jugger18
Yeah, plus that guy is a mere 1.5 hour drive from me. I did buy all the stuff to try some at home zinc plating as well