honda305.com Forum

The pawl is shot. ..........lm

lix wrote:Here is a picture of the kickstarter pawl spindle. Is this still a good one?


P1010222 by Kristof Beheyt, on Flickr

I started with the front shocks so I can paint them:


P1010207 by Kristof Beheyt, on Flickr

I didn't know there were two kind of oil seals. Of course I bought the wrong ones :)

And made a basket for the battery:


P1010213 by Kristof Beheyt, on Flickr

regards

Thank you, do you perhaps know where I can find a new one? David silver and cmsnl doesn't have them anymore.

I probably have the same problem with my kickstart pawl, the kicker doesn't engage at all...

Find a piece of (hardend) steel and a dremel is what I would do...

LOUD MOUSE wrote:The pawl is shot. ..........lm

What's it supposed to look like?

Ya must have a lot of time and talent.
That is a cast part. ............lm

bonjour wrote:I probably have the same problem with my kickstart pawl, the kicker doesn't engage at all...

Find a piece of (hardend) steel and a dremel is what I would do...

Forgot what Mr. Honda himself said ?

Try something, if it fails, you now know how not to do it, try again.

(or something like that)

It can't be all to difficult with a dremel I would say... yes, patience and time, learning and building skills is fun !

A little progress:


P1010227 by Kristof Beheyt, on Flickr


P1010229 by Kristof Beheyt, on Flickr


P1010233 by Kristof Beheyt, on Flickr


I installed new all balls bearings. With the old bearing ring it's easy to install the new one:


P1010234 by Kristof Beheyt, on Flickr


P1010235 by Kristof Beheyt, on Flickr


P1010236 by Kristof Beheyt, on Flickr


P1010238 by Kristof Beheyt, on Flickr

I was just wondering what number 3 is in this parts picture. It's like a rubber cushion but I wasn't on the bike.

http://www.cmsnl.com/honda-cb72-general ... ml#results