Honda305.com Forum

I found a lot of the screws locally thru my Ace Hardware (stainless steel) & those that they were out of stock on, I ordered thru 'Bolt Depot . com'. Can buy EACH, BULK, etc... Great prices even on buying 'each' for those rare sized, long screws used on the side covers where you don't need but 1. Re...

I recently purchased a key thru eBay. Had it in 2 days & cost ~$10.

Ok, I've read what I can find to read on this subject. Both of mine have the rubber stoppers intact ... now that I know where to look for them at. The springs, when at "rest", do not pull the rubber stoppers against the inside of the curcle that they are contained within. with this being said, I wil...

I know this an old thread but I have a similar issue on both my 63 & 64 cb77 advancers (stock). Going to replace the springs nevertheless but here's what I see on both. With the "pawls" pulled away from the center hub, to the point where the spring starts to "take effect" the gap between the pawl & ...

Here I am ... Sunday afternoon trying to reassebmble the gear case. Needless to say, there isn't a moto dealer open till Tuesday around here and the only Cycle shop open on a Sunday is a joke. Some franchise business that seems to cater to clothing more than cycle gear. So, anything equal to Honda o...

Just took my '64 CB77 Frame, Rear Arm & Center Stand in to Mission Finishing in Gilroy, CA to have it blasted & powdercoated in Gloss Black. Should know how it turns out by mid next week. I felt it was fair price @ $180 for the three parts; blast & PC. They also do Chrome, spray chrome, painting, po...

All good information. I've sprayed my gaskets in the past with some sort of a copper spray before installing. Outboard motors for the most part, though.

Just got my cylinders & head back from the oversize bore & valve seating so you know what I'll be doing this weekend!