Honda305.com Forum

So what are you saying Graham, the plugs are dud, or another electrical problem?? I'm at my wits-end just now, fitted a brand-new condenser this morning, & have the same results, SIX new plugs, new leads new caps, tried another coil, a little video shows just whats happening, & i'm beginning to susp...

Hello G man. I am the owner of Summerbud limited who import & sell classic bikes from America! Hello Nick, pleased to meet you, as I have dealt with you twice already, I bought a 750 Bonnie & the CA77 from you off E-Bay, both in need of restos, & I was very satisfied with your prices, descriptions ...

I can accept the scenario of a dud plug, I can also accept a fouled plug, but can't get my head around the fact that it fails/mis-fires when connected, but then runs fine if the plug-cap is pulled off & held a short distance away! I even removed the cap & held the end of the (new) HT lead on the plu...

Is the pin not there?? If its gone, I would get a length of wire & measure the edge of the bearing to the top of the hole, then put the wire down the hole, if the measurement is longer, then the hole in the bearing is somewhere in line, if the same the the bearing was installed wrong or it has alrea...

They are new plugs.

That 'hole' looks like the main bearing retaining pin has burst through the casing, this will happen if the locating pin hole in the bearing 'missed' the pin in the case, so when the cases were bolted up, the bearing outer-race pushed it through, then the perpetrator filled the hole!! Trouble is, no...

Have you tried dropping the needle? Is it a genuine Honda needle or a kit part? Needle jet may be worn. Correct inlet spacer with the strange notch in it? G Sorry, I forgot to mention, CA77 Dream, single carb. 1- Don't know as no markings, ordered new kit. 2- Don't know, ordered new kit. 3- I'll ha...