Think I'm missing some parts!

LOUD MOUSE · Post by **LOUD MOUSE** » Thu Jan 12, 2012 3:56 pm

It's the edge around the top of the bowl and the bottom of the carb.
Square bowl is actually rectangle and the oval has sort of rounded ends. ..........lm

Kigsby wrote:OK...last question I promise. I don't want to beat this horse to death, but I'm just curious. I was just looking at the one on ebay again and comparing it to mine. Mine looks like it has a round float bowl bottom and the one on ebay looks more oval. Is that just my bad eyesight or is that another difference between carbs?

Kigsby · Post by **Kigsby** » Fri Jan 13, 2012 1:58 pm

Just a follow up....I put the brass tube in with locktite, let it sit overnight and put the carb back on last night. It wasn't easy! Having that tube sticking out from the carb made it difficult to get it back on the bolts. It kept hitting against the frame of the bike. I eventually got it on, but it's making me wonder if the carb with the banjo would be even harder to install or easier to install if that banjo unscrews. After I fix a little starter button issue, I'll fire her up!

brewsky · Post by **brewsky** » Fri Jan 13, 2012 6:25 pm

I have the straight screw-in fitting, and if you do not remove it first, it is definately harder to remove/replace the carb.

Can be done, just takes a few more cuss words.

With the banjo, it could be removed first, so there are no issues.

Kigsby · Post by **Kigsby** » Fri Jan 13, 2012 9:30 pm

Good to know! I wasn't sure how that banjo went in or if it could be taken off. Thanks!

LOUD MOUSE · Post by **LOUD MOUSE** » Fri Jan 13, 2012 9:32 pm

Odds are now that ya have yours mounted ya won't need to remove it. ............lm

Kigsby wrote:Good to know! I wasn't sure how that banjo went in or if it could be taken off. Thanks!

Kigsby · Post by **Kigsby** » Fri Jan 13, 2012 9:34 pm

From your mouth to God's ears!