Float removal

noeyes · Post by **noeyes** » Sun May 18, 2014 1:11 pm

Hey Guys. New to the forum. Picked up a '64 CA77 last week.

First off let me say I know nothing about Carbs. Usually if I study it long enough tho, I can kinda grasp it.

One side of the float in my carb looks to be bent down and not level. Got a new float ordered, but not sure how to get the old one out. Is the pin holding it in threaded or is it just pressed in. How do I get it out?

Wanted to ask here before I go banging on it.

Thanks,
Mark

G-Man · Post by **G-Man** » Sun May 18, 2014 1:31 pm

Mark

the pin is a light push fit but corrosion will make it tighter. support the opposite post and try with a very thin punch to tap it gently. Not too hard as the support posts are easily broken.

G

noeyes · Post by **noeyes** » Sun May 18, 2014 3:32 pm

Thanks G!

I'll give a try.

bbap · Post by **bbap** » Sun May 18, 2014 5:40 pm

Mark, G-man is quite accurate. If you do not have a micro-punch, use a small brad nail with the point blunted. Slight tap and she's out, but support the opposite side if any more than a slight tap. Steve

noeyes · Post by **noeyes** » Sun May 18, 2014 7:38 pm

Thanks! I used a screwdriver from a micro set and just barely tapped it with a small hammer. Came right out.