internal throttle

tom0811 · Post by **tom0811** » Thu Jul 10, 2014 12:16 am

Could use some help. Does anyone have an original set of 65 Ca77 bars that they can post a pic or give dimensions on the slot for the throttle? I am putting new bars on my bike and I dont have the original bars. Thanks Tom

Waveblaster · Post by **Waveblaster** » Thu Jul 10, 2014 8:25 am

I am 90% certain the bars are the same for the Ca77 as the CA92 and CA95. At least that was the case on my 1964/65 machines. Aftermarket ones of those are available from Ebay as are the throttle mechanisms. I think a few of the Thai stores stock them.

They measure 700mm end to end

Just an option.

SWARDLAW · Post by **SWARDLAW** » Thu Jul 10, 2014 12:06 pm

I have an original set of bars that I have taken of my ca77. I swapped them out for a set that I made from a lower rise bar (superbike bend). I will measure the bar tonight and get you a length and width for the slot. It's a pretty easy job to make any handlebar fit these bikes.

tom0811 · Post by **tom0811** » Fri Jul 11, 2014 8:05 pm

Thank You that would be great

Waveblaster · Post by **Waveblaster** » Sat Jul 12, 2014 9:05 am

Swardlaw

I am curious to know what method you used to cut the slot?

Greg

Honda305.com Forum

honda305.com Forum

internal throttle

internal throttle