Rear wheel alignment mystery...

R100 · Post by **R100** » Sun Jul 19, 2015 10:23 am

cknight wrote:I mis-typed earlier, the 1.8mm was without the bushings. Did the "way off" plumb bob episode show a right offset? Chase

Thanks Chase.
Yes the plumb bob measurement shows the wheel off to the right. About 1/4".

R100 · Post by **R100** » Sun Jul 19, 2015 10:30 am

rrietman wrote:the most common bent swingarm is a result of a hard lateral hit to the rear wheel. It displaces the swingarm one way or the other, but, because of the structures involved, can leave it parallel with the centerline of the bike. I have seen this a few times on old Honda's. Of course you would want to fix it, but if the chain tracks OK, I wonder if it really affects the ridability at all? I have a CL72 right now with this happening and it rides just fine, just looks a little odd from the rear.
Randy

That was my thought as well. The wheel being off to one side, but still parallel to the centreline. Nice to get some corroboration on that, thanks.

R100 · Post by **R100** » Fri Jul 24, 2015 1:03 pm

Well after various attempts - no success.
Perhaps one of those times when there is wisdom in knowing when to walk away.
Just don't have the skill, equipment or place to be a metal worker.
Purchased a swing arm off E-Bay and am waiting with fingers crossed.

Steverino · Post by **Steverino** » Sat Jul 25, 2015 1:27 am

Don't feel too Bad, I'm on my third one.
S

R100 · Post by **R100** » Sat Aug 08, 2015 12:25 pm

See next.

R100 · Post by **R100** » Sat Oct 10, 2015 10:28 am

A bit late (maybe a lot late) updating this - sorry about that.
The undamaged swing arm I purchased from E-Bay sorted out the alignment problem.
Again many thanks to everyone who helped me out on this one.

Honda305.com Forum

honda305.com Forum

Rear wheel alignment mystery...