Cb77 kick-start cover

Ibaskins · Post by **Ibaskins** » Thu Mar 31, 2016 3:32 pm

I have a 69 superhawk and I've been trying to get the clutch to work. The lever pulled hard and the gears would grind when I tried to engage. I took apart the kick-start cover and noticed some slack in the adjuster. I got a new adjuster and I'm trying to put it back together and I noticed the adjuster hits the magneto when I pull the cable a little bit. I tried adjusting it but I don't get anymore slack out of the cable. Is this a common thing?

AlanW · Post by **AlanW** » Thu Mar 31, 2016 5:29 pm

Is the 8mm ball bearing in on the end of the clutch rod?

Ibaskins · Post by **Ibaskins** » Thu Mar 31, 2016 5:31 pm

jleewebb · Post by **jleewebb** » Fri Apr 01, 2016 9:05 am

Original author is Loudmouse...

Turn cable adjusters in all the way.
On right case loosen the bolt with a 10mm wrench.
Turn the large gray adjuster left/right a couple of times.
Turn it right to stop then back 1/8 inch.
Adjust the lever for apx. 3/8-1/2 inch slack. .............lm

Honda305.com Forum

Cb77 kick-start cover

Cb77 kick-start cover

clutch

from my archives