Shifter pedal sloppy

Dana01 · Post by **Dana01** » Sun Jul 10, 2011 9:41 am

Hi gang.

Has anyone developed a bronze bushing to take up the slack in the shifter pedal?

I replaced the grease-fitting bolt with new repro. The slop is lessened, but the shifter still flops around. A previous post yielded the Aluminum can liner, which I tried, and may try again, but I think I prefer a new pedal or better yet a bronze bushing to line the pedal mount hole.

Thanks!

LOUD MOUSE · Post by **LOUD MOUSE** » Sun Jul 10, 2011 9:52 am

Hows the bolt shaft surface?. ..........lm

Dana01 wrote:Hi gang.

Has anyone developed a bronze bushing to take up the slack in the shifter pedal?

I replaced the grease-fitting bolt with new repro. The slop is lessened, but the shifter still flops around. A previous post yielded the Aluminum can liner, which I tried, and may try again, but I think I prefer a new pedal or better yet a bronze bushing to line the pedal mount hole.

Thanks!

Dana01 · Post by **Dana01** » Sun Jul 10, 2011 10:40 am

Hi Ed.

The bolt (and grease nipple) are new from Nick and look fine. One other thing, with so much slop, I'm afraid any grease I shoot in will ooze back out.

LOUD MOUSE · Post by **LOUD MOUSE** » Sun Jul 10, 2011 2:03 pm

There was/is always some slop with that part. ........lm

Dana01 wrote:Hi Ed.

The bolt (and grease nipple) are new from Nick and look fine. One other thing, with so much slop, I'm afraid any grease I shoot in will ooze back out.

Dana01 · Post by **Dana01** » Sun Jul 10, 2011 2:13 pm

Thanks Ed. I may see if I can get a machine shop to make me a part ... or just look for a new one :)

Honda305.com Forum

Shifter pedal sloppy

Shifter pedal sloppy

Re: Shifter pedal sloppy