Coating of bits and bolts

scrambled egg · Post by **scrambled egg** » Sun Aug 10, 2014 10:50 pm

Hey folks,
I`m just in the middle of the restoration of a `66 Scrambler, and now I decided to plate/coat all the original bolts of the bike. Does anyone know a place in Orange county CA where they do anything like cadmium or zinc coating? I spent some time with searching the web but couldn`t find a place. Any experience? Thank you!

G-Man · Post by **G-Man** » Mon Aug 11, 2014 4:34 pm

Welcome to the forum!

How about.......

http://www.precisionanodizingandplating ... nc-plating

G

ahenthus · Post by **ahenthus** » Mon Aug 11, 2014 10:10 pm

Why not DIY? Eastwood and maybe other companies have plating systems well within the home hobbiest range of ability at a very reasonable cost. I haven't personally done any DIY plating but I'm sure a good search on this forum would yield a gold mine of information on it.

scrambled egg · Post by **scrambled egg** » Mon Aug 11, 2014 11:00 pm

Thank you! I`m already registered but forgot my loginname :)
I`m gonna check out this place in Anaheim.
Ahenthus: I don`t have time and don`t wanna mess up my patio even more with big buckets and wires, there are too many dirty old Honda stuff there already :)