honda305 Home honda305 Auctions honda305 Gallery honda305 Forum Electronic Ignition honda305 Forum honda305 Forum honda305 Forum honda305 Racing honda305 Literature

Auctions  Mailing List    Registry   Marketplace Forum - FULL SCREEN Forum

□ Search
□ FAQ 
  □ MY_ADS
Vintage Honda Owners,
Restorers, Riders and

CA 78 vent tubes

Post Reply
olde-goat Member
Posts: 35
Joined: Thu May 31, 2018 3:25 pm
Location: Winnipeg Canada/Phoenix AZ

CA 78 vent tubes

Post by olde-goat » Sun Jun 21, 2020 8:24 am

I have a question regarding the three vent tubes on a 65 CA78.; head vent and two located on either side of the carburetor. Originally I thought that the tubes ran from the barbed fittings down and on top of the engine case out towards the back of the engine and dumps outside the frame just in front of the rear tire. After installing the engine I find that there is little clearance between the engine and frame to allow the three tubes to exit outside and terminate in front of the tire. Am I wrong in assuming that this is the way to route the tubes? If incorrect, where do the ends of the tubes terminate? Thank you..

Post Reply



CB-77 | CYP-77 | Road Test | Riding Log | Literature | Zen | Marketplace | VJ Survey | Links | Home