darboots - 1961 CA77 from boxes

darboots · Post by **darboots** » Mon Mar 20, 2017 8:28 am

Yes, I've made sure that the cable nipple is fully home into the slide cavity, and the sheath ferrule sits fully into the cable entry on top of the carb.

LOUD MOUSE · Post by **LOUD MOUSE** » Mon Mar 20, 2017 9:13 am

I misunderstood your last reply.
Do you have the correct limiter in the bars?
I have seen 2 designs. .............lm

How bout the area in the top/inside of the slide?. .............lm

darboots wrote:Yes, I've made sure that the cable nipple is fully home into the slide cavity, and the sheath ferrule sits fully into the cable entry on top of the carb.

darboots · Post by **darboots** » Mon Mar 20, 2017 11:22 am

Thanks LM.

Not sure about a limiter in the bars? That's a new one to me.

I managed to shorten the outer sheath, and have now got the following position.

It runs really nicely now, but still needs dynamic timing and fuelling sorting...

LOUD MOUSE wrote:I misunderstood your last reply.
Do you have the correct limiter in the bars?
I have seen 2 designs. .............lm

How bout the area in the top/inside of the slide?. .............lm

darboots wrote:Yes, I've made sure that the cable nipple is fully home into the slide cavity, and the sheath ferrule sits fully into the cable entry on top of the carb.

LOUD MOUSE · Post by **LOUD MOUSE** » Mon Mar 20, 2017 12:04 pm

You are bottomed out now.
In the slot in the bars under the throttle tube is a limiter (throttle cable stopper) which fits at the left end of the slot in a groove and that end of the cable fits there. .................lm

darboots wrote:Thanks LM.

Not sure about a limiter in the bars? That's a new one to me.

I managed to shorten the outer sheath, and have now got the following position.

It runs really nicely now, but still needs dynamic timing and fuelling sorting...

LOUD MOUSE wrote:I misunderstood your last reply.
Do you have the correct limiter in the bars?
I have seen 2 designs. .............lm

How bout the area in the top/inside of the slide?. .............lm

darboots wrote:Yes, I've made sure that the cable nipple is fully home into the slide cavity, and the sheath ferrule sits fully into the cable entry on top of the carb.

bamacl · Post by **bamacl** » Mon Mar 20, 2017 2:40 pm

Unless I'm looking at it wrong, , the slide is in backwards.

bamacl · Post by **bamacl** » Mon Mar 20, 2017 2:41 pm

Unless I'm looking at it wrong, , the slide is in backwards.

LOUD MOUSE · Post by **LOUD MOUSE** » Mon Mar 20, 2017 3:00 pm

You are looking at the open end which is correct. ............lm

bamacl wrote:Unless I'm looking at it wrong, , the slide is in backwards.

Honda305.com Forum

honda305.com Forum

darboots - 1961 CA77 from boxes