Page 1 of 1

SWINGARM AND BEARING CUPS

Posted: Wed Oct 24, 2007 5:21 pm
by DCON
JUST GOT MY FRAME AND SWINGARM BACK FROM POWDER COATERS, SHOULD I SAND THE I.D.S OF THE BUSHING HOLES BEFORE PRESSING IN THE BUSHINGS AND RACES?

Posted: Wed Oct 24, 2007 5:59 pm
by 4shorts
I sure would! Paul

Swingarm rear wheel dampers

Posted: Fri Jul 11, 2008 1:25 pm
by Rhino
Hey there...sounds like you are well on your way with your project...I am on my way to the powdercoat shop as well, but need to remove those damper....how did you get the old one's out, it there a tried and true method....thanks for your time in advance....

swingarm rear wheel dampers

Posted: Fri Jul 11, 2008 2:30 pm
by Rhino
Never mind, but thanks for your consideration, I presssed it out with an oversize socket, a threaded bolt and some washers...they came right out.......thanks again

swing arm fit

Posted: Sat Aug 02, 2008 2:38 pm
by Rhino
Hello all...just got my CL77 frame back from the powder coat shop and I cannot get the swing arm to fit with the two dust seals on the inside....I have filed off all the sufaces of any powder coat but simply cannot get it to fit....any ideas as to what happened to the fit and how I might get it in there.....only one washer/dust seal will fit, I cannot get the other one in on the other side....thanks....