Page 1 of 2
CL72 Project
Posted: Sun Jun 09, 2013 3:34 pm
by malcolmgb
I recently bought this, it looks like it may turn into a retirement project, just over 18 months to my 65th Birthday.
Some things I am going to need are;
Seat
Right side panel
Ignition switch
Coils
Passenger footrests
If anyone has any of these parts please contact me.
Posted: Mon Jun 10, 2013 1:51 am
by G-Man
Malcolm
I can probably help with most of those. I'll look through my pile of parts over the next few days.
Nice looking tank on that project!
G
Posted: Mon Jun 10, 2013 11:07 am
by malcolmgb
Thanks G, yes the tank looks good but I think the tap fittings have been altered. I forgot to include it is also missing handlebars.
Posted: Mon Jun 10, 2013 11:58 am
by G-Man
What about the mudguards / fenders? They should be alloy on early CL72s.
G
Posted: Mon Jun 10, 2013 3:17 pm
by malcolmgb
Yes have alloy guards, I forgot to put them in picture.
The front is very dented I am hoping it can be straightened by a good sheet metal worker, the rear is good but will need some welding around the license plate fixing area. The front guard bracket needs some welding and straightening too, then re-chrome.
Posted: Mon Jun 10, 2013 4:33 pm
by G-Man
You're going to be busy!
G
Posted: Mon Jun 10, 2013 4:44 pm
by malcolmgb
Yes & very poor too I think. How rare are fuel tank knee pads? I have seen replicas but very expensive, I am not planning a concors rebuild just a very tidy daily rider so old parts will be used.
