Cylinder Block Cleaning

uadmlj1 · Post by **uadmlj1** » Fri Dec 17, 2010 4:22 pm

Any recommendations for cleaning/restoring the cylinder block, while installed? Thanks.

LOUD MOUSE · Post by **LOUD MOUSE** » Fri Dec 17, 2010 4:40 pm

Would ya mind adding your location in the profile information?. ....lm

uadmlj1 wrote:Any recommendations for cleaning/restoring the cylinder block, while installed? Thanks.

uadmlj1 · Post by **uadmlj1** » Fri Dec 17, 2010 5:38 pm

Updated profile.

brewsky · Post by **brewsky** » Fri Dec 17, 2010 6:57 pm

I used Simple Green and a small round brush between the fins.
A little time consuming, but turned out good

LOUD MOUSE · Post by **LOUD MOUSE** » Fri Dec 17, 2010 7:26 pm

Thanks there feller.
I think others on the forum are close ta ya. ......lm

uadmlj1 wrote:Updated profile.

uadmlj1 · Post by **uadmlj1** » Mon Dec 20, 2010 6:44 pm

Anyone heard of using a brass wire brush?

LOUD MOUSE · Post by **LOUD MOUSE** » Mon Dec 20, 2010 7:46 pm

I know several fellers who had success with the brass wheels and a drill. ..........lm

uadmlj1 wrote:Anyone heard of using a brass wire brush?

honda305.com Forum