I am now at the point of splitting the cases on my CB 77. This particular job has given me fits on every bike I have worked on. Is there a way to go about this that will make it easier ? ( by the way, I have looked and looked to make sure that I have all the nuts and bolts off. Been there, done that.) Any suggestions will be appreciated. Or am I doomed to just going around and around the cases with rubber hammer till my wife puts an end to the noise in the basement.
Moneypits
honda305.com Forum
Vintage Honda Owners, Restorers, Riders and Admirers
splitting cases
-
Mike Mullins
- honda305.com Member
- Posts: 247
- Joined: Thu Aug 02, 2007 9:24 pm
- Location: Demotte IN
-
Mike Mullins
- honda305.com Member
- Posts: 247
- Joined: Thu Aug 02, 2007 9:24 pm
- Location: Demotte IN