CA77 Head Sealing Washers?

big-b · Post by **big-b** » Mon Apr 04, 2011 7:07 pm

It's not clear to me why some use the sealing washers and some don't? It appears to me that they would all have an equal chance of leaking?

Brian

LOUD MOUSE · Post by **LOUD MOUSE** » Mon Apr 04, 2011 7:08 pm

Consider the make up of the engine and ya may understand. .....lm

big-b wrote:It's not clear to me why some use the sealing washers and some don't? It appears to me that they would all have an equal chance of leaking?

Brian

big-b · Post by **big-b** » Mon Apr 04, 2011 7:51 pm

sorry for all the questions LM but these three with the blue tape are the only ones that need a sealing washer correct?

LOUD MOUSE · Post by **LOUD MOUSE** » Mon Apr 04, 2011 7:55 pm

On the bottom.
If ya look at the area and impact of what the one on the right seals ya will see why a thick aluminum washer is there.
The other 2 don't really matter as HONDA changed to steel washers in 1967. ..............lm

big-b wrote:sorry for all the questions LM but these three with the blue tape are the only ones that need a sealing washer correct?

big-b · Post by **big-b** » Mon Apr 04, 2011 8:03 pm

Front Sprocket shaft?

LOUD MOUSE · Post by **LOUD MOUSE** » Mon Apr 04, 2011 8:09 pm

Now that I look at where ya have the tape the one on the right uses a normal steel washer and the Aluminum washer goes on the stud which comes through the OIL PASSAGE to the Clutch Cover. .......lm

big-b wrote:Front Sprocket shaft?

big-b · Post by **big-b** » Mon Apr 04, 2011 9:46 pm

Sorry, but i'm still not 100% clear on which ones need the sealing washer.

honda305.com Forum

honda305.com Forum

CA77 Head Sealing Washers?