Hello everyone, could use some help on this one- tried the search function but couldn't find the info.
I need to resleeve a cl175 cylinder (twin) and need to know the reccomended "negative tolerance" for a proper job, did this 40+ years ago, but I don't remember the sizing.
Any help will be greatly appreciated.
Allan
honda305.com Forum
Vintage Honda Owners, Restorers, Riders and Admirers
resleeving cylinders
-
bikedoctor99
- honda305.com Member
- Posts: 154
- Joined: Sat Aug 14, 2010 7:11 am
- Location: North Jersey
-
Tim Miller
- honda305.com Member
- Posts: 242
- Joined: Mon Jan 30, 2012 6:22 pm
- Location: Pflugerville, TX
Re: resleeving cylinders
In order to achieve proper heat transfer for cast iron sleeve in alloy cylinder I use .003 to .004 interference.
All the best,
Tim
All the best,
Tim
bikedoctor99 wrote:Hello everyone, could use some help on this one- tried the search function but couldn't find the info.
I need to resleeve a cl175 cylinder (twin) and need to know the reccomended "negative tolerance" for a proper job, did this 40+ years ago, but I don't remember the sizing.
Any help will be greatly appreciated.
Allan