Fuel System: Gas (Petrol) tanks, Carburators
-
Phil-UK
- honda305.com Member
- Posts: 229
- Joined: Thu Oct 19, 2006 7:04 am
- Location: ENGLAND
Post
by Phil-UK » Sat Aug 31, 2013 1:07 pm
Seems they all leak when full but the lip on your tank in the photo looks like it is higher than the surrounding upper surface of the tank. If that is the case then the gasket isn't making contact with that surface. It almost looks domed.
On my CB72 the lip ( i.e. the innermost part that the "ears" go under ) is slightly lower than the top of the tank. Still leaks if full to the brim but OK once the fuel level is @1" below.
Is there another bike or tank you can get a look at to compare ?
Phil
-
Goodysnap
- honda305.com Member
- Posts: 456
- Joined: Mon Oct 06, 2008 7:25 pm
- Location: Lansing , Michigan
Post
by Goodysnap » Sat Aug 31, 2013 6:40 pm
I agree with Phil. Looks like the flange is bent up where the lock tangs grab thus not sealing tight.
Straighten the flange and clean up the gasket surfaces on the tank and cap with a fine scotch brite pad.
64' CB77
65' CB160