clutch assembly

CB450guy · Post by **CB450guy** » Tue Dec 01, 2015 8:14 pm

i see in the fiche two no. 22431-259-000 (ring, clutch plate stopper) i have only one that holds the first plate in. i have two engines both only have the one. do i really need that second one and if i do does someone have one? thanks Ron 518 663 8217

48lesco · Post by **48lesco** » Wed Dec 02, 2015 12:56 pm

Hi Ron - Opinions here are to just leave those out. I've had clutches with and without them and couldn't tell a difference. I think good clean straight plates, proper adjustment, and the right oil is the most important. What's the right oil you ask? Well here goes... I use 30W from Walmart and change it every 1000 miles.
-48

CB450guy · Post by **CB450guy** » Wed Dec 02, 2015 3:17 pm

48 thanks i will use the one that is in place and wont worry about the second one i have lots of steel plates and will get new fibre ones thanks again Ron

48lesco · Post by **48lesco** » Wed Dec 02, 2015 7:04 pm

Hey Ron one more thing if you're going to leave that ring in there. That first metal plate came in a thin and later a thick version and the fiber ones come in different thicknesses too so the holes for those wires are only in the right place for the plates that came with that clutch from the factory. That can be hard to determine and there's lots of posts about it if you search this site. LM rebuilds a lot of these and may have more/better info.

CB450guy · Post by **CB450guy** » Thu Dec 03, 2015 5:45 am

48 gotya arent these 305 fun!Ron

LOUD MOUSE · Post by **LOUD MOUSE** » Thu Dec 03, 2015 6:22 am

I'll call ya if you want. ...........lm

CB450guy wrote:48 gotya arent these 305 fun!Ron

Honda305.com Forum

honda305.com Forum

clutch assembly

clutch assembly

clutch

clutch assembly

Re: clutch assembly