RH Crankcase clutch adjuster grease/clutch rod seal '66 CB77

[LOUD MOUSE]

If you have the original filter ya can cut the tube from it (cut about 1/4 in. around) and JB Weld it to the new filter at the same location. .....................lm

Thanks, Tim!

[Glenn-N]

Good point about the dirt Ed.

I'll mount it behind the airfilter, same place where the wire harness sits.

[LOUD MOUSE]

As AIR GOES INTO the tube NOT OUT you may want to just put a tube between the 2 nipples on the head. .............................

Good point about the dirt Ed.

I'll mount it behind the airfilter, same place where the wire harness sits.