CL77 Gear Shifting Pattern

Hoosier Tom · Post by **Hoosier Tom** » Thu Oct 19, 2017 10:43 am

Mrburnn wrote:Nice catch, yes I did have the retainer installed upside down. Unfortunately I still cannot operate through the gears, even using the shifter arm...........JoeM

Does that mean you have moved the retainer after that photo was taken?

HT

Mrburnn · Post by **Mrburnn** » Thu Oct 19, 2017 1:16 pm

Yes, I moved the retainer this morning.

cknight · Post by **cknight** » Thu Oct 19, 2017 1:24 pm

You should temporarily install the left engine cover, then the shift arm, to properly support the shifter shaft, otherwise it will be deflecting too much when trying to rotate it. Also, turn the output shaft in both directions to accomplish stationary gear changing. Regards, Chase

Mrburnn · Post by **Mrburnn** » Thu Oct 19, 2017 9:22 pm

Thanks for all the help! I'll keep working on it.

JoeM

Mrburnn · Post by **Mrburnn** » Sat Oct 21, 2017 7:18 am

A final update. My shifting issue was caused by my having 2nd gear on the counter shaft on backwards. This prevented the one fork from sliding into 1st, thus the transmission always being in neutral. I feel kinda foolish but yet happy since I can now begin the reconstruction phase. Thanks to everyone who offered help, even Mr. Bill Silver himself! Very honored to receive his expert advice!!

JoeM

honda305.com Forum

honda305.com Forum

CL77 Gear Shifting Pattern

Problem Solved