Disassemble speedometer gear assembly

LOUD MOUSE · Post by **LOUD MOUSE** » Mon Jan 21, 2019 2:29 am

How will the grease get to the inside of the hub?. ..........lm

rrietman wrote:But--- go easy, you can blow grease past the seal very easily and then where is it? on the brake shoes. just lube on assembly. clean and repeat now and then.
Good luck
Randy

DJM · Post by **DJM** » Mon Jan 21, 2019 12:09 pm

I was just wondering the same thing?

rrietman · Post by **rrietman** » Tue Jan 22, 2019 12:20 am

was thinking of a different bike, sorry. my advice does apply to greasing the brake cams though.
Thanks
Randy

LOUD MOUSE · Post by **LOUD MOUSE** » Tue Jan 22, 2019 3:59 am

Not that I'm perfect however I do attempt to address the bike in question. ..........................lm

quote="rrietman"]was thinking of a different bike, sorry. my advice does apply to greasing the brake cams though.
Thanks
Randy[/quote]

Tim Allman · Post by **Tim Allman** » Tue Jan 22, 2019 11:04 am

The excess grease problem may be why the brake cam fittings are not found on the later models.

LOUD MOUSE · Post by **LOUD MOUSE** » Tue Jan 22, 2019 11:23 am

Or maybe found to not be necessary?. ..................lm

Tim Allman wrote:The excess grease problem may be why the brake cam fittings are not found on the later models.

DJM · Post by **DJM** » Tue Jan 22, 2019 11:36 am

Could be either or both of the above plus cost issues too.

Honda made more and more of thee models as the years went by and a few cents saved on each one would have mounted up.

honda305.com Forum

honda305.com Forum

Disassemble speedometer gear assembly

Speedo drive,

CB72 Brake Greasing