starter clutch questions

overthehill · Post by **overthehill** » Mon May 14, 2007 12:48 am

HI EVERYONE, Can someone tell me what size puller I need and how to get the starter clutch
off of a 1965 305 dream? I have Bill's manual on the bike but it does not mention these things
Thanks for all the help,Terry

Hahnda · Post by **Hahnda** » Mon May 14, 2007 8:56 am

You can use the rear axle as a puller. I have a pdf of how to fix it that I got off this site. Can't find the download and can't attach it. I could send it direct by email.

overthehill · Post by **overthehill** » Mon May 14, 2007 8:46 pm

Thanks Kevin,If you dont mind I would like to see that,you can send it to tgagnon1@tds.net
Thanks again,Terry

Hahnda · Post by **Hahnda** » Tue May 15, 2007 8:37 am

email sent

overthehill · Post by **overthehill** » Wed May 16, 2007 7:04 am

Thanks Kevin,I got the email,This sheds a whole new light on this.Iam going to order a puller,
Would you know where I can get the springs for this? Thanks again,Terry

Hahnda · Post by **Hahnda** » Wed May 16, 2007 8:06 am

Don't know on the springs, you might be able to match something up at the spring drawer at the local hardware store. I think I remember someone talking about replacements but can't remember the details. When I had mine apart I found that the springs were fine, its just that everything had a layer of corrosion on it that was causing problems. Take it apart, clean everything up, and see what you need.

kustommusic · Post by **kustommusic** » Wed May 16, 2007 4:23 pm

OTH, Iv'e rebuilt two of 'em now and I got my springs from ; DavidSilverspares.com.uk
There could be others that have them but I'm not sure who. Good Luck, Steve Greer

Honda305.com Forum

honda305.com Forum

starter clutch questions

starter clutch questions