65 Dream won't run without full choke

djbarcy · Post by **djbarcy** » Thu Aug 07, 2008 8:29 am

Carb is clean and bike runs fine with full choke.
With choke off, motor stalls.
Help please.

Thanx
dan

LOUD MOUSE · Post by **LOUD MOUSE** » Thu Aug 07, 2008 8:33 am

You say "carb is clean" so have you removed and cleaned the jets and idle passages?. ..................lm

djbarcy wrote:Carb is clean and bike runs fine with full choke.
With choke off, motor stalls.
Help please.

Thanx
dan

djbarcy · Post by **djbarcy** » Thu Aug 07, 2008 9:38 am

LOUD MOUSE · Post by **LOUD MOUSE** » Thu Aug 07, 2008 9:50 am

Slide installed with the cut away toward the air side? (visible from the intake).
Hose on the brass tube at the bottom of the float bowl?. ..............lm

djbarcy wrote:Yes

djbarcy · Post by **djbarcy** » Thu Aug 07, 2008 10:03 am

yup and yup
I was just able to get her to run at idle with the choke off by playing with the 2 screws on the left side but as soon as I give her any throttle she bogs.
Thanx
dan

LOUD MOUSE · Post by **LOUD MOUSE** » Thu Aug 07, 2008 10:05 am

How open is the air screw?. .............lm

djbarcy wrote:yup and yup
I was just able to get her to run at idle with the choke off by playing with the 2 screws on the left side but as soon as I give her any throttle she bogs.
Thanx
dan

djbarcy · Post by **djbarcy** » Thu Aug 07, 2008 10:35 am

Now there's an interesting question.
If it is the one just under the frame that sticks straight out (as opposed to the other one that is closer to the motor and in at an angle), I have tried it everywhere from all the way in to out 3 or 4 turns and there is not much change.

Honda305.com Forum

65 Dream won't run without full choke

65 Dream won't run without full choke

Re: 65 Dream won't run without full choke