rear sets

banksc1970 · Post by **banksc1970** » Wed Sep 30, 2009 10:38 am

Anyone know where I can get rear sets from?

mike69 · Post by **mike69** » Wed Sep 30, 2009 11:18 am

Rear sets of what?

banksc1970 · Post by **banksc1970** » Wed Sep 30, 2009 5:29 pm

Foot pegs! Moves them back for a riding position in more of a forward lean (like you need on a cafe). Seems like I have seen some adjustable ones somewhere, but I can't remember where I saw them!

banksc1970 · Post by **banksc1970** » Wed Sep 30, 2009 6:16 pm

I think these may fit! Anyone have an opinion about the fitment of these on the CB77?
They offer several different distances between the holes, but I measured 110mm.

http://cgi.ebay.com/ebaymotors/Universa ... ccessories

davomoto · Post by **davomoto** » Wed Sep 30, 2009 8:44 pm

You do realize that the stock pegs can be relocate backwards? there are two more rearward positions to move them to. You will need to make a longer shifter rod, threaded rod, and two rod ends. Not as bling as a cnc'd set-up, but way cheaper!

davomoto

banksc1970 · Post by **banksc1970** » Thu Oct 01, 2009 6:58 am

Thanks Davo. I didn't realize it until I went to measure the bolt holes. I was looking at the plates and saw the other 2 holes located further back and at that point realized I could use the stock setup and still move them back a little. I may still go the with the fancy shmancy set up as I have to get new pegs and shift rods and shifter and rubber and all that for the stock set up anyway. I'll have to do a cost benefit analysis!

Honda305.com Forum

honda305.com Forum

rear sets

rear sets

rear sets

Think I found them on ebay