CB125

linmictil2 · Post by **linmictil2** » Mon Aug 22, 2011 5:04 pm

Evening Gents: I am looking for a T-Handle box wrench 16 mm . Part. No. 07086-28301
This wrench is used to take off the locking nut that holds the oil filter on a CB125 . I have looked all over and have yet to find. I tried making one to no avail. Rebuilding this little bike for my granddaughter... Thanks for any help..
Mike

mike horvath · Post by **mike horvath** » Mon Aug 22, 2011 10:16 pm

Mike,
If you haven't aleady, my suggestion would be to contact Nick at Ohio Cycle. Although your part isn't listed on his site, maybe he can help.

FAST FRED · Post by **FAST FRED** » Mon Aug 22, 2011 10:29 pm

Motion Pro sells a locknut wrench like that Part Number 08-0015. It fits a 3/8" socket wrench.

Fast Fred

Hahnda · Post by **Hahnda** » Mon Aug 22, 2011 10:36 pm

I think this might be what you are looking for.

http://search.ebay.com/160593443135

linmictil2 · Post by **linmictil2** » Tue Aug 23, 2011 6:13 am

This is great!! Thank you everyone!! BIG TIME!!! I looked all over for this and couldn't find it any where. I guess my search skills are a little lacking. I want to clean the clutch plates but you can't get them out without pulling the oil filter body first. I ground down a small pair of vise grips but snapped the ends off when I put pressure on them. Tried a punch but that started screwing it up inside so before I trashed it I stopped.. Needle nose pliers were close but didn't get it.. Thanks again Gentlemen-- you made my day.... Mike

Honda305.com Forum

honda305.com Forum

CB125

CB125

T handle wrench

MOTION PRO

wrench