Hello guys , last year my father bought a honda CB72E racer with some special parts ; tomaselli clip ons - four leading front brake - akront rims - high compression pistons - close ratio gearbox etc etc . this week it was alive for the first time , was not running so well but after modifying the jets it serious kicked some ass :) Did a couple of test runs , and discovered a leak at the outgoing gearbox shaft , where the front gearwheel is fitted,i think its the seal inside the bronze bush !! Not shure ,, but ok now my question ; does anyone have a drawing how its all fitted ? i cant see it from the outside . So if anyone can help us , in advance thank you ! attached a picture from the gearbox shaft and the machine complete ... excuse me for my drossy english but normally i write/speak dutch !! http://img514.imageshack.us/img514/4284/img0498qv7.jpg http://img514.imageshack.us/img514/4284/img0498qv7.d1bf051053.jpg http://img117.imageshack.us/img117/1508/hpim1466mr0.jpg http://img514.imageshack.us/img514/372/hpim1465sh9.jpg http://img514.imageshack.us/img514/372/hpim1465sh9.4276952949.jpg