Clutch Rod Interference?

Dogsbd · Post by **Dogsbd** » Mon Aug 11, 2008 8:43 pm

Test fitting the right hand side case cover today it seemed that the clutch lifter rod was sticking out too far and I could not push the cover one because of it. What is it that I may have done (in clutch assembly I assume) to cause this?

1966 CA77

joeweir1 · Post by **joeweir1** » Mon Aug 11, 2008 9:00 pm

Clutch adjuster installed wrong in the side cover would be my first guess.Have a photo?How far out is the rod sticking?Did you have the clutch apart?

Dogsbd · Post by **Dogsbd** » Tue Aug 12, 2008 6:49 am

Yes, I did have the clutch apart. The rod sticks out past the gear 2 - 2.5 inches. I'll try to get a picture or two this evening.

joeweir1 · Post by **joeweir1** » Tue Aug 12, 2008 3:40 pm

can you push in on the rod at all?

Dogsbd · Post by **Dogsbd** » Tue Aug 12, 2008 4:07 pm

joeweir1 wrote:can you push in on the rod at all?

I cannot.

Here is the picture:

Dogsbd · Post by **Dogsbd** » Wed Aug 13, 2008 8:39 am

I think I have it sorted, removed the clutch and reinstalled and it seems to work fine now.

Thanks

joeweir1 · Post by **joeweir1** » Wed Aug 13, 2008 9:59 pm

honda305.com Forum

honda305.com Forum

Clutch Rod Interference?

Clutch Rod Interference?