Looking for an early CB72 front fender

LOUD MOUSE · Post by **LOUD MOUSE** » Mon Aug 09, 2010 9:05 am

The very first frame has a Smashed Tube with a slot in it.
The later (not much though) has a cast part brazed to the tube. ................lm

slarsonroy wrote:LM- I should be able to get a pic of the rear seat mount later today. Anything particular that you're looking for? I'll take a couple close-ups.

slarsonroy · Post by **slarsonroy** » Mon Aug 09, 2010 5:42 pm

LM, Look like the "Later" version that you mentioned.

TDF · Post by **TDF** » Mon Aug 09, 2010 8:43 pm

slarsonroy wrote:Hey Toby!!! I see you EVERYWHERE man!

We do seem to run in the same circles don't we. I sent you an email at the address listed in your profile on this site with some info about your CB72 etc. I tried the email address I had from you from a year and half ago or so when I bought the Ducati's and the MDS off of you but it bounced back, must a been an older account.

TDF

slarsonroy · Post by **slarsonroy** » Mon Aug 09, 2010 8:56 pm

Toby, Bentbike62 is the correct address. The L2speed one is gone. Got your email. Lots of good info. Havent had time to read it yet but looking forward to it. Thanks!

jensen · Post by **jensen** » Tue Aug 10, 2010 12:35 am

Hi,

How is your speedo mounted, with screws or with a spring ? (spring in the lamp housing)

Jensen

LOUD MOUSE · Post by **LOUD MOUSE** » Tue Aug 10, 2010 7:44 am

YA it's a 62 and later frame and will take the regular seat frame not the early short one. ..............lm

slarsonroy wrote:LM, Look like the "Later" version that you mentioned.

slarsonroy · Post by **slarsonroy** » Tue Aug 10, 2010 10:07 am

Thanks lm, that is good info to know.

honda305.com Forum

honda305.com Forum

Looking for an early CB72 front fender