installing head, positioning question

big-b · Post by **big-b** » Sat May 28, 2011 3:53 pm

I just slid the cyl over the pistons. Does this look positioned correctly so i can take the next step and slide the head on?

Brian

CL77NOW · Post by **CL77NOW** » Sun May 29, 2011 1:51 pm

rings were staggered per FSM?
per Silvers books.?
are you working with or with out books, its a key point for help. (ground zero or?)

this silvers books also show key spots to put Permetex non-harding on the gasket hear OIL feeds.
stopping wick effect.

LOUD MOUSE · Post by **LOUD MOUSE** » Sun May 29, 2011 1:56 pm

Be sure to install the 2 cylinder to head studs. ............lm

big-b wrote:I just slid the cyl over the pistons. Does this look positioned correctly so i can take the next step and slide the head on?

Brian

CL77NOW · Post by **CL77NOW** » Sun May 29, 2011 4:37 pm

very good , 2x 6mm studs missing.
L&R

e3steve · Post by **e3steve** » Sun May 29, 2011 4:41 pm

CL77NOW wrote:very good , 2x 6mm studs missing.
L&R

FAST FRED has the JIS screws you need.

CL77NOW · Post by **CL77NOW** » Sun May 29, 2011 4:51 pm

thank, i just thanked im on pm mail

never thought id ever get them.
was getting ready to tig weld, iSO heads to JIS. shaft.
last resort.

my so lucky, thanks !

big-b · Post by **big-b** » Tue May 31, 2011 8:31 am

Thanks guys,

They're in there, just not in this pic. The head is on.

Brian

honda305.com Forum

honda305.com Forum

installing head, positioning question

installing head, positioning question

Re: installing head, positioning question