1962 CB77 Restoration underway

flathead · Post by **flathead** » Tue May 31, 2011 10:50 am

Tom,

Looking thru all your pic's I didn't see a shot of the inside of the head. I almost messed up once and used a CL/CB72 head on a 305 engine. I didn't check for interference as I caught it early. Just a thought.

Mark

Hoosier Tom · Post by **Hoosier Tom** » Tue May 31, 2011 11:05 am

Mark,

Thanks for the thought. It is a 305 head, the piston fits the dome.

Regards- Tom

Hoosier Tom · Post by **Hoosier Tom** » Thu Jun 02, 2011 3:38 pm

OK, got the cylinders back from the bore and hone to S4. This time around I will use NOS cams and cam sprocket. They are the later shallow spline assys, so I dug around to find a points cam assy that had the smaller diam to fit the cam hole.

HT

hillhudson · Post by **hillhudson** » Thu Jun 02, 2011 5:51 pm

lookin good!

Hoosier Tom · Post by **Hoosier Tom** » Thu Jun 02, 2011 11:02 pm

Cams are in now. I forgot to note earlier I keep a piece of copper pipe handy to lock the cam sprocket when I tighten or loosen the sprocket nut.

HT

hillhudson · Post by **hillhudson** » Fri Jun 03, 2011 1:07 am

tom, will you be making a head gasket for the oversize bore ? or will you be buying one ?

e3steve · Post by **e3steve** » Fri Jun 03, 2011 3:27 am

Good call, using the copper pipe to lock the sprocket! Did you smack the nut tight with a blunt chisel? Or did you use the toolkit's pin wrench?

honda305.com Forum

1962 CB77 Restoration underway