ca77 valve adjustment on new engine

[win1906]

so i have rebuilt a ca77 engine following bill silver engine rebuild book.everything was real good until i got to valve adjustment.as i understand the ca77 engine is a 360 with both pistons at top dead center when the stater is on (t).i have the cam dot on top.so what side valves do i adjust first and then rotate 1 turn and adjust the other side.

[easy305]

Adjust the tappets on the side which has both valves closed,then as you say rotate engine through one complete revolution and set tappets on remaining side

[easy305]

Make sure you have the 360 engine (one set of points) as the earlier engine (two sets of points) is different

[win1906]

thanks for the reply but the head was completely taken apart so both sides have the valves completely closed.

[Hahnda]

If your cam and rockers are back in then the valves on both sides can't be closed unless you have the adjusters backed all the way off.

[win1906]

correct the rockers were taken apart and cleaned.so the adjusters are backed off.

[LOUD MOUSE]

Which earlier engine do you mean?. ..........lm

Make sure you have the 360 engine (one set of points) as the earlier engine (two sets of points) is different