main stand spring hook

3BeanCrispy · Post by **3BeanCrispy** » Tue Apr 29, 2008 6:16 pm

is the main stand spring hook supposed to be flat or rounded, in perspective to the thickness axis. sohuld it lay flat as if cutout from a piece of sheetmetal ? or as if it was cutout then bent/shaped? mine looks like a c-shaped egg cradle

LOUD MOUSE · Post by **LOUD MOUSE** » Tue Apr 29, 2008 8:30 pm

Stamped from sheet steel. ................lm

3BeanCrispy wrote:is the main stand spring hook supposed to be flat or rounded, in perspective to the thickness axis. sohuld it lay flat as if cutout from a piece of sheetmetal ? or as if it was cutout then bent/shaped? mine looks like a c-shaped egg cradle

3BeanCrispy · Post by **3BeanCrispy** » Thu May 01, 2008 8:25 pm

thanks ! i figured it should be flat, but wanted to double check before flattening it.

how about the rear brake rod ? i'm guessing it should be straight and not generously arced over it's length.

milwaukeephil · Post by **milwaukeephil** » Mon May 12, 2008 3:56 pm

Speaking of springs, I almost took an eye out on my CL350 last summer, so used this method to put the spring on with no swearing involved. Stuck one end of the spring in a vise and bent it back and forth adding pennies, then put it on the bike and pulled the pennies with a pliers...

3BeanCrispy · Post by **3BeanCrispy** » Mon May 12, 2008 4:16 pm

quite innovative ! adding that one to my bag of tricks hehe

milwaukeephil · Post by **milwaukeephil** » Mon May 12, 2008 4:21 pm

Wish I could take credit; don't remember who told me to try it but it works great...

fallingpines305 · Post by **fallingpines305** » Mon May 12, 2008 6:30 pm

Not many tools cost 43 cents these days, you did well.

Honda305.com Forum

honda305.com Forum

main stand spring hook

main stand spring hook

Re: main stand spring hook