The bottom ring is obvious, but the top two on mine were indiscernibly different. New set looks just like what's in the photo. Thanks in advance.
P.S. I tried to search the forums in advance, I couldn't find anything.

Spargett wrote:I was curious as to the order of piston rings. I found this photo below, but I just wanted to check with you guys to make sure that it's correct. Just because someone put a picture of it on the internet, doesn't always mean it's right ; )
The bottom ring is obvious, but the top two on mine were indiscernibly different. New set looks just like what's in the photo. Thanks in advance.
P.S. I tried to search the forums in advance, I couldn't find anything.
LOUD MOUSE wrote:LOCATIONS ARE CORRECT. BE SURE NUMBERS ARE UP. ...........lm
Spargett wrote:Thanks for the info guys. LM, not sure what you mean by the "numbers up".
LOUD MOUSE wrote:LOCATIONS ARE CORRECT. BE SURE NUMBERS ARE UP. ...........lm
Davo, thanks, saw reference to that in Bill Silver's manual. Always appreciate the reminders.LOUD MOUSE wrote:YOU WILL SEE NUMBERS ON THE RIGHT SIDE OF THE OPEN END IF YOU HAVE THE RING "TOP UP". ..........lm
davomoto wrote:Also, be sure to put the end gaps 120 degrees apart.