toolbox brackets

maia · Post by **maia** » Fri Feb 26, 2010 8:57 pm

Silly me for not photo-documenting but I've got a tool box with missing tabs for the side covers it looks like (I'll jury rig something till I can get a new toolbox) but what gets mounted to those two tabs? Thanks

Goodysnap · Post by **Goodysnap** » Fri Feb 26, 2010 9:29 pm

Basically they are small 90 degree brackets that are spot welded where the holes are. They have a nut welded to them for the side cover screws. I looked for a picture but didnt find a good one for ya.Good used ones show up on the bay often.

LOUD MOUSE · Post by **LOUD MOUSE** » Fri Feb 26, 2010 10:39 pm

The starter solinoid. ...........lm

maia wrote:Silly me for not photo-documenting but I've got a tool box with missing tabs for the side covers it looks like (I'll jury rig something till I can get a new toolbox) but what gets mounted to those two tabs? Thanks

Gunner_CAF · Post by **Gunner_CAF** » Sat Feb 27, 2010 8:58 am

Here are a few pictures I found that may help. The first shows the box mounted without the starter solenoid, the second has the solenoid mounted, but a little hard to see.

Gunner

davomoto · Post by **davomoto** » Sat Feb 27, 2010 11:11 am

Here's a link to an NOS one for sale on Ebay. Has some good pics of what missing brackets should look like. Way overpriced in my opinion, hold out for a used one.

davomoto

http://cgi.ebay.com/ebaymotors/Honda-CB ... 19b8c03c78

maia · Post by **maia** » Sat Feb 27, 2010 12:27 pm

Thanks a lot guys.

G-Man · Post by **G-Man** » Sat Feb 27, 2010 1:04 pm

Maia

This is the toolbox off my recently dismantled CB77. Yours looks good enough just to make up and attach some little tabs with welded-on nuts.

G

honda305.com Forum

honda305.com Forum

toolbox brackets

toolbox brackets

Re: toolbox brackets