305'rs,
Looking for an Upper Crankcase Cover # 90706-268-000
Got one laying around, thought I'd try here 1st.
Also need a left side dust cover/sheild.
Thanks all,
WTB Upper Crankcase Cover CB77 S' Hawk
-
- honda305.com Member
- Posts: 101
- Joined: Tue Jan 04, 2011 11:20 am
- Location: Halton Region, ON, CDA
- Contact:
WTB Upper Crankcase Cover CB77 S' Hawk
Last edited by roadcapDen on Thu Feb 17, 2011 11:09 am, edited 1 time in total.
roadcapDen
2 HD XL's
65 Dream 305
and a bunch of other scoots
2 HD XL's
65 Dream 305
and a bunch of other scoots
-
- honda305.com Member
- Posts: 7818
- Joined: Mon Aug 15, 2005 8:23 am
- Location: KERRVILLE, TEXAS
Re: WTB Upper Crankcase Cover C78 Dream
The C78 engine/bike doesn't use that cover. .........lm
roadcapDen wrote:305'rs,
Looking for an Upper Crankcase Cover # 90706-268-000
Got one laying around, thought I'd try here 1st.
Also need a left side dust cover/sheild.
Thanks all,
-
- honda305.com Member
- Posts: 101
- Joined: Tue Jan 04, 2011 11:20 am
- Location: Halton Region, ON, CDA
- Contact:
-
- honda305.com Member
- Posts: 7818
- Joined: Mon Aug 15, 2005 8:23 am
- Location: KERRVILLE, TEXAS
-
- honda305.com Member
- Posts: 101
- Joined: Tue Jan 04, 2011 11:20 am
- Location: Halton Region, ON, CDA
- Contact:
-
- honda305.com Member
- Posts: 7818
- Joined: Mon Aug 15, 2005 8:23 am
- Location: KERRVILLE, TEXAS
-
- honda305.com Member
- Posts: 101
- Joined: Tue Jan 04, 2011 11:20 am
- Location: Halton Region, ON, CDA
- Contact:
Thx for asking, got the cylinder top off last night and the cylinder head and could see the cam chain master link down about 6 inches at the front of the engine, miracurosly got the clip and outside link off but there wasn't enough side play to get the link out, almost there but not enough. The link is at the bottom but got the chain out.
Stuck pistons were cleaned up a bit, now soaking in CLR, tried pounding w/ some wood but nothing yet. Gonna try some heat and try to make a pusher out of 1/4 steel plate to go over the studs...
The valves are stuck and the cam doesn't move, didn't see any recommendations in Mr Silvers CD???
Should they now move freely? I'm thinking yes?
Stuck pistons were cleaned up a bit, now soaking in CLR, tried pounding w/ some wood but nothing yet. Gonna try some heat and try to make a pusher out of 1/4 steel plate to go over the studs...
The valves are stuck and the cam doesn't move, didn't see any recommendations in Mr Silvers CD???
Should they now move freely? I'm thinking yes?
roadcapDen
2 HD XL's
65 Dream 305
and a bunch of other scoots
2 HD XL's
65 Dream 305
and a bunch of other scoots