Trick with pulling the rotor off?

GarageRacer · Post by **GarageRacer** » Sat Nov 19, 2011 1:02 am

Is there a trick to pulling the rotor (from the charging system) off? I see I need 07933-2160000, is there any alternatives to using that tool?

Mike Mullins · Post by **Mike Mullins** » Sat Nov 19, 2011 7:34 am

You can use a 16 mm. bolt with a 1.5 mm. pitch. Might be hard to find. I could not find any bolts on my CB 77 that will do it. Needs to be about 2" long or so.
Mike Mullins

davomoto · Post by **davomoto** » Sat Nov 19, 2011 11:11 am

Do a serch on this site for rotor puller. Click on "all terms" to limit the search.

Davo

rrietman · Post by **rrietman** » Sat Nov 19, 2011 11:50 am

the rear axle off a dream has the correct thread and will work as a rotor puller. not sure about the axle off a cb tho.
Randy

Mike Mullins · Post by **Mike Mullins** » Sat Nov 19, 2011 10:10 pm

Rear axle froma CB will not work.
Mike

GarageRacer · Post by **GarageRacer** » Sat Nov 19, 2011 10:40 pm

Yeah I tried just for the hell of it. I went to Tacoma Screws today and they weren't open so I'll hit them on monday and get the bolt.

The rotor isn't a terribly big concern at the moment. I'm having trouble removing a stuck bolt. My easy out broke on it and I can't get the broken bit out to drill the bolt.

rustywrench · Post by **rustywrench** » Sun Nov 20, 2011 2:10 am

Go to Harbour freight and pick up a chain break tool. Large thread of the tool will remove that rotor. Yeah I know, most of us don't like to support them but what the hell, you get two tools in one. Rusty

Honda305.com Forum

honda305.com Forum

Trick with pulling the rotor off?

Trick with pulling the rotor off?

re:pulling rotor

tools