'67 Hawk Elctrical Gremlins, i.e. what am I looking at here?

[LOUD MOUSE]

It starts inside the cover with the alignment of the gear marks and the spring then on outside the lever must be installed/aligned with the punch marks and as you place the cover on the engine you must align the "O" then install the cover.
SIMPLE !
Well when you get it right you will not forget how to do it. ......lmk

Thanks Man!

Not the place for it - but any quick link on how to align the Kick Starter, i.e the dot's and "o's" on the gears?

Suffering from a limp K/S arm and Viagara ain't helping! :)

Gersh

[dagersh]

Just to make sure -

The spring should look llike an "S" looking at the installation?

The "O"s should be aligned or do I load up tension and align the punches?

I caught your posts on the spring direction.

Also, how coiled should the spring be? I have one that is pretty tight and one that is, well, significantly loose. The loose one cam off my original cover that shattered at the K/S Bushing...

Thanks LM!

Gersh

[dagersh]

LM,

Searching as we are speaking - I think I forgot to turn the transmission gear all the way clockwise before installing the cover....

Gersh

[LOUD MOUSE]

There ya go. ..................lm

LM,

Searching as we are speaking - I think I forgot to turn the transmission gear all the way clockwise before installing the cover....

Gersh

[dagersh]

Thanks LM!

Now back to our regularly scheduled Elctrical Topics!!!

Gersh

[davomoto]

The part in your last pic appears to an electronic ignition control module. Have you removed the points cover to see what behind it?

Davo

[dagersh]

Davo,

I will check that out. As I was looking at the wires coming out of the box, I traced them up to the points, but ran out of time.

I am going to pull the harness next weekend and record where these wires are hooked into. I will update as I go.

Thanks for the response!

Gersh