Honda CA77 Ring Gap

pcnss123 · Post by **pcnss123** » Thu Dec 20, 2012 7:51 am

Hi everybody! i am currently restoring a 1963 ca77, i have stripped the motor due to a blown head gasket.

Could anybody tell me what the end ring gap should be for a heahly set of rings, as im struggling to find any info

Any help would be appricated!

conbs · Post by **conbs** » Thu Dec 20, 2012 10:45 am

Shop manual says compression .15-.35 mm and oil .1 -.3 mm.

pcnss123 · Post by **pcnss123** » Thu Dec 20, 2012 10:58 am

Thanks for your reply!

Could you explain what that means at all?

Many thanks

G-Man · Post by **G-Man** » Thu Dec 20, 2012 5:21 pm

they are the values for the two compression rings and the oil control ring.

G

pcnss123 · Post by **pcnss123** » Fri Dec 21, 2012 7:39 am

Thanks a lot for your help! Turns out the rings are really worn so I have some new ones on the way!

Thanks again

conbs · Post by **conbs** » Fri Dec 21, 2012 10:11 am

How do your pistons and cylinders spec out?

pcnss123 · Post by **pcnss123** » Sun Dec 23, 2012 9:16 am

This ring gap turned out to be a massive 2mm! I can only get 0.12 between the piston and barrel, so hopefully just new rings

Honda305.com Forum

honda305.com Forum

Honda CA77 Ring Gap

Honda CA77 Ring Gap

Ring end gap

Piston wear