1966 Honda Scrambler Restore---JS

sarals · Post by **sarals** » Sun Apr 14, 2013 11:13 am

And I'll reply (thank you for the kind words)!

It looks good to me, but I'd feel better hearing LM say that.

jsmith1107 · Post by **jsmith1107** » Sun Apr 14, 2013 2:59 pm

All was going well until this happened. I started tightening the left corner bolt and it twisted completely off. I guess I will need to get that thing out of there---Ed said to just grab it with a good vice grip and it will twist out. FUN FUN

sarals · Post by **sarals** » Sun Apr 14, 2013 4:12 pm

Oh, fudge!!! I'm sorry that happened. Ed is probably right, it should come right out.

You do know that the head bolts only take 12 to 14 foot pounds of torque?

mike in idaho · Post by **mike in idaho** » Sun Apr 14, 2013 4:24 pm

I would drop a nut over what's left of the stud and weld the hole full, then while it's still warm back it out with a wrench. Might help to warm up that corner of the case as much as you can first.

jsmith1107 · Post by **jsmith1107** » Sun Apr 14, 2013 5:20 pm

Ok, I got it out---just used a vice grips and it came out. I hope the other one comes out and I can swap them. My nerves are at the end. Haha

LOUD MOUSE · Post by **LOUD MOUSE** » Sun Apr 14, 2013 5:59 pm

As I told you "It will come out"!. .....lm

jsmith1107 wrote:Ok, I got it out---just used a vice grips and it came out. I hope the other one comes out and I can swap them. My nerves are at the end. Haha

jsmith1107 · Post by **jsmith1107** » Sun Apr 14, 2013 8:43 pm

it came out and now here I am AGAIN

honda305.com Forum

honda305.com Forum

1966 Honda Scrambler Restore---JS